PVC rods holders used on the piers.

[bigmike]

Hi Folks,
Would anybody have info on how to make them PVC rod holders than can be used on the pier. Please send info to me via email to
[e-mail] thanks happy holidays everybody.

[riverviewsteve]

Big Mike you can tailor them to your own needs but
his the way I made mine. If I remember correctly the
1 1/2 pvc pipe that I used was ten foot long. So I just
measured how high up I wanted them and then cut
them off at that length. Also I put wye's on the end of
mine and caps on the bottom so they wouldn't wear
out so fast. I put a hole in the cap so water could run
out. I'm going to try and get out there before I go on
vacation. Are you still out there every day? If I make
it your welcome to look mine over and see if that's
what you want.
So here's mine
1 1/2 inch cap for the bottom
1 1/2 inch wye on top
11/2 inch pvc pipe cut to length.
Oatey Cement
I also fastened a link of heavy chain to mine
with a pipe strap so I can tie them down tight if
I want to. I use bungi cords and rope to keep
them from moving around. If you want them heavier
duty I guess you could go to the next size pipe.
Take care my friend. riverviewsteve

[bigmike]

Ok,
Thanks Steve.
My days off are wed & thursday Steve say hi to your wife for me.

[truckyfd]

ditto for me, but i don't cap the end because some of the conduit are barely off the pile enough to fit the pipe

and i direct tie mine to the upright of the rail with small rope!